D1252
Alpha Keypad
Radionics D360 LED Keypad
| At a
Glance! |
|
| Arm: | [Code] Shortcuts: [COMMAND][1] Arms All; [COMMAND][2] Arms Perimeter w/ no delay; [COMMAND][3] Arms Perimeter w/ delay. The shortcuts can be disabled in programming, though usually aren't. |
| DisArm: | [Code] |
| Check Faulted Zones | If zones are faulted, keypad will display [NOT READY TO ARM]. Press any numeric key on the keypad to view faulted zones. |
| Smoke Reset: | After silencing panel with [Code], press [COMMAND][4][7] to reset smokes. |
| Code Change: | [COMMAND][5][5],
Old Code; New
Code; New code again. D8112A
and D8112E panels, the command is [COMMAND][5]. Most panels are
D8112G models that use Command 55. Note: If you use Command 55, the user code will be a 6 digit number and the first 2 digits must stay the same (they are the user #). If you use Command 5, the user code will be a 5 digit number and the first digit must stay the same (it is the user #). This command can be disabled in programming, though it usually isn't. |
| Chime Mode On/Off: | [COMMAND][6] turns on/off the "Watch Mode". |
| Force Arm Over Open Zones: | If
using [Code] to arm, hold
last digit until panel arms over open zones. If using Command
1,2 or 3,
press [COMMAND] and hold down the
digit 1,2 or 3 until panel arms over
open zones. This command can be disabled in programming, though it usually isn't. Also, programming can restrict how many faulted zones are allowed to be forced armed over. |
| Power Down Panel: | Pull wire from NP7-12 battery, pull
off wire on terminal 1, upper left
corner of panel. |
|
D1252
Alpha Keypad
|
Radionics D360 LED Keypad |