The panel is a Radionics 2000 series

The panel is either a 2012, 2112, 2212, or 2412. These panels work almost identically. The main difference is number of zones and features.

At A Glance!
Arm: Press [9] to Arm All; Press [0] to Partial Arm
DisArm: Enter Code (If you are still in exit time, just press [CLEAR] to disarm.)
Check Faulted Zones: Faulted zones display automatically when faulted.
Smoke Reset: After silencing siren by entering code, press [3] + code to reset smokes.
Code Change: Enter [5], then [Old Code], then [New Code] same # of digits as old code, then [New Code] again.
Chime Mode On/Off: Press [7], keypad will display current setting.
To Change, enter code + [1] to turn off, [2] to turn on short beep, [3] to beep until CLEAR key is pressed, or [4] to beep until point closes.
Bypass Zone(s): Press [Zone #] + *.
Power Down Panel: Pull wire on NP7-12 battery, disconnect AC wire, upper left terminal on board.


The keypad for these panels is the same. It is either an LED keypad (no screen) or an Alpha keypad. The Alpha keypad looks like this:

These user guides should work for any of the 2000 series panels:

  1. User Guide D2212 panel - Alpha Keypad
  2. User Guide D2212 panel - LED Keypad

Other Documents:

  1. Installation Guide D2012 panel
  2. Programming Guide D2012 panel
  3. Installation Guide D2112 panel
  4. Programming Guide D2112 panel
  5. Programming Guide D2212 panel
  6. Installation Guide D2412 panel

Return to the Beginning of the Wizard